Slopestairs bustransferium, Andel
For the construction of the new bus transferium on the Hoge Maasdijk in Andel, the municipality of Altena chose a 3D-printed slopestairs. The stairs connect the bus stop on top of the dike with the transferium, providing direct access to the site for travelers.
Type of project:
Slope stairs
Year:
2025
Contractor:
Van der Plas Civiel B.V.
Commissioned by:
Gemeente Altena
3D printed length:
9 Meters
3D-printed slopestairs for bus transferium Andel
After seeing several 3D-printed slope stairs, the municipality of Altena contacted 3D.Weber to explore the possibilities. Key reasons for this choice were the short delivery time, the ability to design a tailor-made staircase, the sustainable execution, and the lower weight of the prefab staircase. The latter reduces the risk of settlement compared to traditional concrete steps. Based on these advantages, the municipality decided that a 3D-printed slope stair was the most suitable solution.
The project was realized through close cooperation between the municipality of Altena, 3D.Weber, and Van der Plas Civiel B.V. The stairs consist of three elements and has a total length of nine meters, a height of 4.37 meters, and a width of two meters. It was delivered at the beginning of June and installed a few days later. Thanks to good coordination and planning, the stairs could be safely and sustainably installed and put into immediate use.
Receive infopaper 3D-printed slope stairs
Curious about all the benefits? Fill in your details and receive our Infosheet 3D-printed slope stairs and tailor-made advice.